Error Messages - Panasonic SA-BX500 Operating Instructions Manual

Error messages

Message
1
U701
2
U703
3
U704
REMOTE 1
4
or
REMOTE 2
CANCEL MUTING
5
FUNCTION
NO C AND LS/RS
6
SPEAKERS
NO LS/RS
7
SPEAKERS
NO LS/RS AND SBL/
8
SBR SPEAKERS
NO SBL/SBR
9
SPEAKERS
NOT POSSIBLE FOR
10
ANALOG 8CH INPUT
NOT POSSIBLE FOR
11
THIS INPUT SOURCE
PCM FIX
12
(flashing)
13
SELECT SPEAKER A
14
SPEAKERS ARE OFF
NOT SUPPORT FOR
15
THIS WIRELESS
SYSTEM
The equipment connected by the HDMI cable is not compatible with the unit's copyright
protection technology.
Should anything unusual happen using an HDMI connection:
Consult your dealer if the sign remains on the display after these steps.
• Turn the connected equipment off and on again.
• Pull out the HDMI cable then reinsert it.
• Reduce the number of equipment connected in series to the HDMI terminal if exceeding 2
units.
The unit has received a signal for a picture format that is incompatible with the HDMI connection.
Check the settings of the connected equipment.
Match the modes on the main unit and the remote control.
Muting is on.
Press [MUTING] on the remote control to cancel the function (➔ page 31).
Center and surround speakers are set as absent. Change their setting to present (➔ page 37).
Surround speakers are set as absent. Change their setting to present (➔ page 37).
Surround and surround back speakers are set as absent. Change their setting to present
(➔ page 37).
Surround back speakers are set as absent. Change their setting to present (➔ page 37).
You are trying to use the effect unavailable for analog 8-channel playback.
You are trying to use the effect unavailable for the current input source.
The unit is in the "PCM FIX" mode. Cancel this mode (➔ page 39).
"SPEAKERS A" is off. Select "SPEAKERS A" (➔ page 26).
"SPEAKERS A" and "SPEAKERS B" are off. Select "SPEAKERS A" or "SPEAKERS B"
(➔ pages 26 and 27).
Not compatible with this wireless system (➔ page 23).
Cause/countermeasure
53
RQT9223