Related Manuals for Walker Edison DT41
Summary of Contents for Walker Edison DT41
- Page 1 ITEM#: DT41 Assembly Instructions Please visit our website for the most current instructions, assembly tips, report damage, or request parts. www.walkeredison.com Revised 03/2017 Copyright © 2010, by Walker Edison Furniture Co., LLC. All rights reserved.
- Page 5 Screw cam bolts (B) into top panel (1). Insert dowels (A) into shelf (7). Attach door stopper (D) to top panel (1) using small screws (E). Attach nylon strap (P) to top panel (1) using small screw (Q). Screw cam bolts (B) into side panels (3,4).Insert dowels (A) into side panels (3,4).
- Page 6 Attach side panels (3,4) to shelf (7) using cam bolts and dowels as guides. Insert cam locks (C) into shelf (7) and tighten with a screwdriver. Attach bottom panel (2) to the assembly from Step 3 using large bolts (F) and wrench (G).
- Page 7 Attach top panel (1) to the assembly from Step 4 using cam bolts and dowels as guides. Insert cam locks (C) into top panel (1) and tighten with a screwdriver. Secure back panel (9) to the assembly from Step 5 by gently hammering nails (H) into the assembly at the points shown above.
- Page 8 Insert shelf support pins (I) into the stand assembly at desired shelf heights. Carefully place shelves (8) onto shelf support pins (I). Note that there will be two shelf support pins on either end of each shelf. Attach handles (J) to doors (5,6) using medium screws (K). Attach hinges (L) to doors (5,6) using flat-head screws (M).
- Page 9 Attach doors (5,6) to the assembly from Step 7 using flat-head screws (M) at hinges (L).
- Page 10 Step 11 (Optional) Walker Edison Furniture Company strongly recommends that this item is attached to a wall to prevent it from falling over. Due to the wide variety of wall types, the necessary hardware for wall attachment may not be included. There is included in this package large screw (R) and plug (S) for use in general wall attachment.