Häfele Height adjustable pull out larder unit Assembly Manual

Assembly guide
Component parts
1 x Frame (A)
Check off components as shown in diagram and lay on flat surface
1
Working outside the carcase, secure the two part frame together by
inserting one of the four connector strips into the bottom section of
the frame and align the holes. BE CAREFUL NOT TO LET THE CONNECTORS
SLIP DOWN INSIDE THE MAIN FRAME! Insert the one of the eight M5 x 10mm
screws. Repeat this procedure for the other three frame connectors as shown
in the drawing making sure the cut outs in the frame are on the same side top and
bottom, Slide the top section of the frame over the secured connectors
aligning the holes and secure using the remaining four M5 x 10mm screws.
Make sure the screws are securely tightened before proceeding.
Height adjustable pull out larder unit:
3 x Brackets (B)
3 x Plate (C)
1 x Guide roller (D)
2 x Door connecting strips (E)
1 x Runner (F)
4 x Frame
connectors (G)
Basket (H)
Installed height 950 - 1200 mm = 3 baskets
Installed height 1200 - 1450 mm = 4 baskets
Installed height 1450 - 1700 mm = 4 baskets
Installed height 1700 - 1950 mm = 5 baskets
Installed height 1950 - 2200 mm = 5 baskets
Sales and Technical Support - Sales and Technical Support -
Tel: 01788 542020, Fax: 01788 544440, E-Mail: info@hafele.co.uk Tel: 01788 542020, Fax: 01788 544440, E-Mail: info@hafele.co.uk
Tools required (Not Supplied)
Spirit Level
Bradawl
Did you know Häfele also supply tools to the trade and industry?
See www.hafele.co.uk for more information.
•
•
•
•
•
•
•
2 x M6 x 50 mm 2 x M8 x 40 mm
Round head bolt (J)
Connecting bolt (I)
12 x M5 x 6.0 mm 36 x M4 x 15 mm
Round head bolt (M) Pan head screw (N)
48 mm pins
x 2 per basket (Q)
Cross Head Screwdriver
SW4 Allen key
Pencil
Make sure all the components are included before
you start.
The number for technical support is at the bottom
of the page.
Don't rush!
Read the instructions first.
Assemble in the stages shown.
Keep the fittings together to avoid loss.
Have fun.
2 x M6 x 25 mm
Round head bolt (K)
8 x M5 x 10.0 mm
Flat head screw (O)
pin caps
x 2 per pin (R)
Flat head screw
Threaded hole bracket
500.00-0102
FITT-10057
Issue - 01
Tape measure
2 x M6 x 10 mm
Round head bolt (L)