Macro Mode - Canon PC1057 User Manual

Macro Mode

Mode Dial
Use the macro mode to shoot close-ups of subjects when the
distance from the tip of the lens to the subject is in the following
range (varies according to the zoom position):
Zoom Position (35mm film equivalent) Distance to the subject
Wide angle end – 63 mm
63 – 90 mm
90 mm – telephoto end
* The zoom position appears in 35mm film equivalent values.
1
Press the
appears on the display panel and the
LCD monitor (or in the viewfinder).
Press the
macro mode.
2
Shoot the image.
Shooting procedures are the same as for the
When you turn the zoom ring, the zoom bar accompanied by the
yellow bar under it appears. The yellow bar shows the zoom range
in which you cannot shoot the subject in Macro mode.
If the zoom bar enters the yellow bar range, the macro mode icon
will appear in gray after the zoom bar disappears. You can still
shoot the image, however, the macro mode is canceled.
Zoom bar
button.
button again to cancel the
Yellow bar
Approx. 2 seconds
later
10 – 50 cm (3.9 in. – 1.6 ft.)
30 – 50 cm (1.0 – 1.6 ft.)
Macro shooting not available
Appears in gray
mode (p. 53).
73