Setting The Jpeg Quality (Compression Rate); Jpeg Quality (Compression Rate) - Canon MARK III EOS-1 DS Instruction Manual

If the viewfinder displays "99" for the maximum burst, it means the maximum
burst is 99 or higher. If 98 or lower is displayed, the maximum burst is 98 or
lower. If you stop the continuous shooting, the maximum burst will increase.
After all the captured images are written to the memory card, the maximum
burst will be as listed on page 53.

3 Setting the JPEG Quality (Compression Rate)

The image-recording quality (compression rate) can be set for each
image size 3/4/5/6.
The higher the image-recording quality, the fewer the number of possible
shots will be. On the other hand, the lower the image-recording quality, the
higher the number of possible shots will be.
Select [JPEG quality].
1
Under the [2] tab, select [JPEG
quality], then press <0>.
Select the image size.
2
Turn the <5> dial to select the
image size, then press <0>.
Set the desired quality
3
(compression rate).
Turn the <5> dial to select setting,
then press <0>.
The higher the number, the higher the
quality will be (lower compression).
For 6 - 10, <i> is displayed. For 1 -
5, <o> is displayed.
Setting the Image-recording Quality
55