Subwoofer Level; Speaker Level Adjustments; Other Useful Functions; Sleep Timer - Panasonic SC-HT730 Operating Instructions Manual

SUBWOOFER

Subwoofer level

LEVEL
You can adjust the amount of bass. The unit automatically selects
the most suitable setting according to the type of playing source.
Press [SUBWOOFER LEVEL].
≥When DVD-Video or DVD-RAM is selected
SUB W 4 (factory preset)>SUB W 1>SUB W 2>SUB W 3
^--------------------------------------------------------------------------}
≥When another source is selected
SUB W 2 (factory preset)>SUB W 3>SUB W 4>SUB W 1
^--------------------------------------------------------------------------}
DISC TUNED
DIGITAL
PL DTS
CD MODE
RDS PS PTY W
DVD RAM
The setting you make is retained, and recalled every time you play
the same type of source.
TEST

Speaker level adjustments

SHIFT CH SELECT
This is one of the ways to get appropriate surround effects.
Preparation
Press [DVD/CD].
1
While stopped and no on-screen display is shown
Press [SHIFT]i[TEST] to output a test
signal.
L: Front left C: Center
RS: Right surround LS: Left surround
≥There is no output from SW (subwoofer) channel.
2
Press [VOLUME, r] or [s] to set the
volume level normally used for listening.
3
Press [3] (increase) or [4] (decrease) to
adjust the speaker level for each speaker.
C, RS, LS: `6 dB to i6 dB
(L, R: Only the balance is adjustable.)
≥To adjust the balance of the front speakers
While outputting the test signal, press [2, 1].
≥Adjust the speaker level to the same level as the front
speakers.
To stop the test signal
Press [SHIFT]i[TEST] again.
∫ To adjust speaker level during play
(Effective when playing multi-channel audio or when Dolby Pro
Logic II or Super Surround is on.)
1
Press [CH SELECT] to select the speaker.
# # # # #
L C R RS LS
^-------------------------------------------------}
SW: Subwoofer
≥You can adjust SW only if the disc includes a subwoofer
channel.
≥"SW" does not appear on the display and is not adjustable
when Dolby Pro Logic II is turned on.
≥"S" appears on the display when "MUSIC" or "MOVIE" is
selected with Super Surround (➜ page 30). In this case, you
can adjust both surround speaker levels at the same time
using [3, 4].
S: `6 dB to i6 dB
2
Press [3] (increase) or [4] (decrease) to adjust the
speaker level for each speaker.
C, RS, LS, SW: `6 dB to i6 dB
(L, R: Only the balance is adjustable.)
≥To adjust the balance of the front speakers
While "L" or "R" is selected, press [2, 1].
T G S.SRND D.MIX SLP MONO STCT
L
LS
S
RND
PGM
H.BASS
R: Front right
SW

Other useful functions

SLEEP

Sleep timer

SHIFT QUICK OSD
Press [SHIFT]i[SLEEP] to select the time (in
minutes).
SLEEP 30_----)SLEEP 60_----)SLEEP 90
^""""" OFF(_ SLEEP 120(__}
To cancel the timer
Press [SHIFT]i[SLEEP] to select "OFF".
C R
RS
LFE
To confirm the remaining time
12
PRG
Press [SHIFT]i[SLEEP] again.
To change the setting
Repeat the procedure from the beginning.
SETUP

Muting

MUTING
Press [MUTING].
"MUTING" flashes on the unit's display.
DIGITAL
PL DTS
MODE
CD
RDS PS PTY W
DVD
RAM
To cancel
≥Press [MUTING] again or reduce the volume to minimum (– – dB),
then raise it to the required level.
≥Muting is canceled when you switch the unit to standby.

Using headphones

M
ain unit only
1
Reduce the volume and connect the
headphones (not included).
Headphone plug type: 3.5 mm (
1 2 3 4 5
INPUT
POWER
SELECTOR
5 DISC SELECTOR
2
Adjust headphone volume with
[VOLUME].
≥Audio is automatically switched to stereo (2-channel).
[Note]
Avoid listening for prolonged periods of time to prevent hearing
damage.
DISC TUNED T G S.SRND D.MIX SLP MONO STCT
z) stereo
1 /
8
H.BASS PROGRESSIVE CD MODE
TUNE MODE FM MODE MEMORY
D.MIX SLP
C R
L
LS RS
S
LFE
RND 12
PGM PRG
H.BASS
VOLUME
OPEN CLOSE DISC EXCHANGE DISC SKIP
VOLUME
PHONES
DOWN UP
TUNING
RQT7972
31