Panasonic SC-HT730 Operating Instructions Manual page 6

Simple setup
1
STEP Front speaker assembly
[HT933]
2 Front speakers
1
Attach the pipe to the base.
1
Thread the speaker cable through the base.
Lessen excess
speaker cable.
Groove
2
Insert the pipe.
Insert the pipe while gently
pulling on the speaker cable.
3
Secure the pipe to the base.
Ensure the screws are
securely fastened by lightly
tightening the left and right
side screws alternately until
fully tightened. (The heads of
the screws protrude slightly
even if you have fully
tightened them.)
The supplied stands are specially designed for
attachment to Panasonic SB-PF920 front speakers.
Only use as indicated in this setup.
2
Attach the stand to the speakers.
≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
Ensure the stand is fastened on straight by lightly tightening the top
and bottom screws alternately until fully tightened.
Front speaker
Polyfoam
Connection terminals
You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram on the
RQT7972 right when attaching the stand to the upper rear or lower rear of
the speaker.
6
2 Pipes
Thread the speaker
cable through here.
Cable
Holes for screws
Rear side of base
Small screws
Mounting plate
2 Bases
∫ Front speaker height
(Assembled diagram)
1,138 mm
z)
(44 13 /
16
Attach to lower
rear of speaker
3
Adjust the speaker height.
≥Check the screws you tightened in procedures
and speaker are loose.
e.g. Attaching the stand to the lower rear
1
Loosen the attached speaker mounting
plate screw until the attached speaker is
slightly loose and adjustable.
Large
screws
Cable Be careful not to loosen the screw
too much or the speaker may detach
and fall.
2
With one hand on the base and the other
holding the speaker adjust the height of
the speaker up and down.
≥After adjusting the height tighten the screw
on the mounting plate securely.
Phillips-head screwdriver
For your reference
You can enjoy good acoustics by
adjusting the height of the speaker to
the height of the television so the
center positions of both are
approximately the same.
4 Large screws
Speaker
You can adjust within this range.
968 mm 796 mm
z)
z)
(38 1 / (31 11 /
8 32
625 mm
Pipe
(24
Base
Attach to upper
rear of speaker
Stopper screw
Screw to stop mounting plate from
moving or sliding below this point.
4 Small screws
678 mm
z)
(26 11 /
16
Stopper
screw
z)
19 /
32
Do not
remove.
1 2
and if the pipe