Panasonic SC-HT730 Operating Instructions Manual page 5

[HT930]
[Note]
To prevent the speaker cables from being pulled out of the pipes, leave the plastic wrap on the pipes while
assembling the speaker stands.
2 Front speakers
1
Assemble the speaker stands.
1
Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the hole, and then pull
the rest of the cable through the base.
Plastic wrap
Leave the excess speaker
cable for connecting later.
2
Insert the pipe.
Pipe
Groove
Pipe support
Insert the pipe while gently
pulling on the speaker cable.
3
Secure the pipe to the base.
Ensure the screws are securely fastened.
Short screws
Before proceeding to the next step, please remove the plastic
wrap from the pipe.
2 Pipes 2 Bases
Cable
Base
Match the groove and these
holes with the base when you
insert the pipe.
Base
Phillips-head screwdriver
(not included)
4 Long screws
2
Attach the stands to the speakers.
Ensure the stand is fastened on straight by gradually tightening the
top and bottom screws alternately until fully tightened.
Long screws
You can also attach to the lower rear of the speaker.
The height of the speaker can be changed when attaching the
stand to the upper rear or lower rear of the speaker.
3
Connect the speaker cables.
Twist off the vinyl tips of the
speaker cables.
≥If the speaker cables do not
have vinyl tips, directly connect
them to the terminals.
_:
Copper
`:
Silver
Push!
Press the speaker cable into the
groove.
If there is any excess speaker cable, thread the speaker cable
into the opening near the top of the pipe while pulling the speaker
cable from the bottom of the base.
4
Secure the speaker cables to the bases.
Press the speaker cable into
the base cover groove as far
as possible.
Cable
4 Short screws
Pipe
Front speaker
Rear of the speaker
Rear side
of base
Groove
RQT7972
5