Panasonic SC-HT730 Operating Instructions Manual page 7

4
Connect the speaker cables.
Twist off the vinyl tips of the speaker
cables.
≥If the speaker cables do not have vinyl
tips, directly connect them to the
terminals.
_:
Copper
`:
Silver
Push !
Press the speaker cable into the
groove.
If there is any excess speaker cable, thread
the speaker cable into the opening near the
top of the pipe while pulling the speaker
cable from the bottom of the base.
5
Fasten the speaker cable to the base.
≥Using the same polyfoam as in procedure
safely and securely fastening the speaker cables.
1
Press the speaker
cable and thread
between the
hooks.
Rear side of base
∫ Preventing the speakers from falling over
Preparation
Rear of the speaker
Attach screw eyes (not included) to secure the speakers to the wall
(➜ diagram below).
≥You will need to obtain the appropriate screw eyes to match the
≥Consult a qualified housing contractor concerning the
To prevent the speaker from falling over, thread the string (not
included) from the wall to the speaker as shown and tie tightly.
2
will assist you in
2
Fit the speaker
cable into the
base cover
groove as far as
possible.
Cable
walls or pillars to which they are going to be fastened.
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
[HT730]
[HT733]
String (not included)
Rear of the speaker
[HT930]
String (not included)
Rear of the speaker
[HT933]
String (not included)
Rear of the speaker
Screw eye (not included)
Approx.
150 mm
z)
29
Wall (5 /
32
Screw eye (not included)
Approx.
150 mm
Wall
z)
(5 29 /
32
Screw eye (not included)
Approx.
150 mm
z)
29
(5 /
Wall
32
RQT7972
7