Ricoh B245-62 Service Training page 114

Four levels: A – D (See notes)
Reset 'Level A' codes with SP 7807
» Level A codes cannot be reset by only switching the
machine off/on.
Slide 114
There are four levels of service call conditions.
Level A: To prevent damage to the machine, the main machine cannot be
operated until the SC has been reset by a service representative (see the note
below).
Reset: Enter SP mode, and then turn the main power switch off and on.
Level B: If the SC was caused by incorrect sensor detection, the SC can be reset
by turning the main power switch off and on.
Reset: Turn the main power off/on.
Level C: The main machine can be operated as usual, excluding the unit related
to the service call.
Reset: Turn the main power off/on.
Level D: The SC history is updated. The machine can be operated as usual.
No reset needed. The SC will not be displayed. Only the SC history is
updated.
SC Codes
114
B245-62 / PD-C4