Table of Contents
Advertisement
Alignment and Adjustmens
4.10 Error Message
Display
Door Open
The front cover is not securely latched.
Hsync Error
A problem has occurred in the LSU
(Laser Scanning Unit).
[Invalid
There is invalid foner install.
Cartridge]
Low Heat Error
There is a problem in the fuser unit.
[LSU Error]
A problem has occurred in the LSU
(Laser Scanning Unit).
[No Paper]
The paper in the paper input tray has run
Add Paperr
out.
Open Heat Error
There is a problem in the fuser unit.
[Over Heat]
There is a problem in the fuser unit.
[Paper Jam 0]
Paper has jammed in the feeding area
Open/Close
of the paper input tray.
Door
[Paper Jam 1]
Paper has jammed in the fuser area or
Open/Close
in the manual feeder.
Door
[Paper Jam 2]
Paper has jammed in the paper exit area.
Check Inside
Power Failure
Power has turned off then on and the
machine's memory has not been back up.
Scanner Error
There is a problem in the scanner unit.
Service Manual
4-10
Meaning
Suggested solutions
Close the cover until it locks into place.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Installed authorized toner cartridge.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Load paper in the paper input tray.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Clear the jam.
Clear the jam.
Clear the jam.
The job which you were trying to do before the
power failure must be completely re-done.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Samsung Electronics
Advertisement
Table of Contents
Troubleshooting
