Cisco Nexus 9332D-GX2B Hardware Installation Manual page 19

Installing the Chassis
• Ensure that the chassis can be adequately grounded. If the switch is not mounted in a grounded rack, we
recommend connecting the system ground on the chassis directly to an earth ground.
• Ensure that the site power meets the power requirements for the switch. If available, you can use an
uninterruptible power supply (UPS) to protect against power failures.
• Ensure that circuits are sized according to local and national codes. Typically, this often requires one or
both of the following:
Caut i o n Avoid UPS types that use ferroresonant technology. These UPS types
can become unstable with the switch, which can have substantial
current draw fluctuations because of fluctuating data traffic patterns.
• AC power supplies typically require at least a 15-A or 20-A AC circuit, 100 to 240 VAC, and a
frequency of 50 to 60 Hz.
Caut i o n
To prevent loss of input power, ensure the total maximum loads on
the circuits supplying power to the switch are within the current
ratings for the wiring and breakers.
Note For AC input application, please refer to the statement below:
W a r n i n g Statement 1005 Circuit Breaker
This product relies on the building's installation for short-circuit
(overcurrent) protection. Ensure that the protective devices is rated
not greater than 20A (North America), 16A (Europe), and 13A (UK).
Note For DC input application, please refer to the statement below:
W a r n i n g
Statement 1005 Circuit Breaker
This product relies on the building's installation for short-circuit
(overcurrent) protection. Ensure that the protective devices is rated
not greater than 40A for the regular DC power supplies (rated
48-60VDC) and 10A for the HVDC power supplies.
Cisco Nexus 9332D-GX2B NX-OS Mode Switch Hardware Installation Guide
Installation Guidelines
13