Assembly - General 850-3 Manual

ASSEMBLY INSTRUCTIONS
BEFORE
For your convenience this saw is shipped from the factory partially assembled and requires only minimal assembly
and set up before being put into service. The left and right table extension wings are factory installed and aligned
and unless seriously shaken or jolted in transport should not require further alignment.
If purchased with the standard General "T" Fence System, a full installation and operating instructions manual for the
fence system is supplied in the box.
If purchased with the table board extension and support legs or if adding an aftermarket table board and legs,
installation instructions can also be found in the fence manual.
Before connecting the machine to the power source, verify that the voltage of your power supply corresponds with the
Voltage specified on the motor ID nameplate
INSTALL AND ADJUST RAILS AND FENCE
ATTACH THE FRONT FENCE RAIL TO YOUR SAW
Referring to the diagram above,
rail to the front of the saw.
NOTE: The front rail, is the wider of the two rails and has holes in both faces.
ADJUST THE FRONT RAIL HEIGHT
0
Place the supplied L-jig on top of the table. Adjust the rail height until the bottom of the jig is flush with the rail shelf. Hold
the nuts firm with a 7/ 16" wrench and the two screws on left and right ends of the rail. Tighten the center screws only
after double-checking rail height using the L-jig all along the rail and at both ends.
.
This tool is for INDOOR use ONLY! Do NOT use in wet or damp locations.
place 4 flat head countersunk screws, lock washers and nuts to assemble the front
But d on 't tighten the nuts yet.