Programmable Features - Code Alarm CA-420 Installation Instructions Manual

PROGRAMMABLE FEATURES:

Feature LtsFlash1X
1. Run Time 5 Min.
2. Ign. 2 Off during start
3. Park Lights ON
4. Tach Mode Tachless
5. Voltage Level > 0.5V B4 Start
6. Diagnostics Off
7. Start Time 0.8Sec
8. Gas/Diesel Gas
9. BTN Press 1 Press Start
To Program Features:
1. Turn the ignition key to the ON position.
2. Press and release the program switch 3 times.
3. Immediately turn the ignition key OFF, then back to ON.
4. Press and release the program switch 2 times
5. Use the program switch to advance to the feature that you want to change. EXAMPLE - If you need to change
programmable feature number 3, press and release the program switch 3 times in succession. The parking
lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Press The Vehicle's Brake to change the selection of the programmable feature. If you are not sure what the
setting for any feature is, press the brake one time, the parking lights will flash once or twice, etc... indicating
the features setting.
NOTE: Once you enter the feature-programming mode, do not allow more that 15 seconds to pass between
steps, or the programming will be terminated.
Lts Flash 2X Lts Flash 3X
10 Min. 15 Min.
On during start
Flash
Tach
< 0.5V B4 Start
On
1.0 Sec 1.5 Sec
Diesel 10 Diesel 15
2 Press Start
8
Lts Flash 4X Default
20 Min. 10 Min.
On
ON
Tach
> 0.5V
Off
2.0 Sec 1.0
Diesel 20 Gas
2 Press Start
128-6832
8 of 16