Remote Control - Whynter ARC-147WFH Instruction Manual

Remote Control

Power Control
On / Off
Fan Speed
:HIGH :MED
On / Off Timer
In running mode: Auto switch
off In stand-by mode: Auto
switch on
Press or button to
adjust the time settings.
Fahrenheit / Celsius
Notes:
- Do not drop the remote control.
- Do not place the remote control in a
location exposed to direct sunlight.
- The remote control should be placed
about 3 feet or more away from any
appliances.
Battery Placement :
Remove the cover on the back of the remote control and insert the batteries with the ( + ) and ( - ) poles pointing in the proper
direction.
CAUTION:
！
Use only AAA batteries.
Remove the batteries if the remote control is not used for a month or longer.
Do not attempt to recharge the supplied batteries.
All batteries should be replaced at the same time, do not mix old battery .
Do not dispose of the batteries in a fire as the batteries may explode.
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 4 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Page 12
 
:LOW
1.5V
1.5V
I / O
F / C
1.5V
LCD Display
Time / Temperature Set Control
For adjusting the timer and temperature.
●
The default display on control panel is room
●
temperature.
When or key is pressed in cool
mode, the set temperature is displayed and
may be adjusted. After few seconds the
display will revert back to room temperature.
Timer setting is available from 1-24 hours
by pressing the key
Mode Control
Press this button to change the
operation mode in the order
Cool
Fan
or .
Dehumidify
Heat