Table of Contents
Advertisement
7. Close the front cover.
When the front cover is closed, the paper initialization process will be carried out (5 blank sheets will be fed
out).
* In order to facilitate media color adjustment, media type recognition, and print quantity management,
an IC chip is built into the ink ribbon. Media without an IC chip, which has not been evaluated and
cleared, may not function properly. (If correct data cannot be read from the IC chip, an alarm will sound.
In this case, in order to protect the printer, it will lower the concentration for printing.)
* Please change the media as a set, because the IC chip for each ribbon has unique information.
Otherwise, errors could occur.
* If different width media (for example L-size and PC-size) are used on the same printer, problems with
the print quality could arise. Therefore, it is preferable not to mix the use of different width media on
one printer.
8. Set the Scrap Box to the printer.
CAUTION
・ When the scrap box is removed, do not insert your fingers in the cutter at the top. They could be
cut or severed.
・ As prints are cut, the scrap box fills with scrap paper. Be sure to empty it when you change the
paper and ribbon. If it becomes over-filled with scraps, it could cause problems with the printer.
・ Exchange the paper and ribbon as a set, in order to avoid a trouble.
S
S
15
e
t
t
i
n
g
U
p
t
h
e
e
t
t
i
n
g
U
p
t
h
e
P
r
i
n
t
e
r
P
r
i
n
t
e
r
Advertisement
Table of Contents
