The User-Definable Waveform - Owon AG4081 User Manual

(1) Press button, then press F4 to enter the Built-in Wform menu.
(2) Press F1 - F4 to select Common, Maths, Window or Others. E.g. select Maths
to enter the following interface.
(3) Turn the knob or press
select ExpRise. Press F1 to output the Exponential Rise waveform.

The User-Definable Waveform

Press button and press F5 to select "Editable Wform".
Menu item
Create Wform
Select Wform
Edit Wform
How to Create a New Waveform
(1) Enter the operation menu: Press
(2) Set the number of waveform points: Press F1
knob or press the number keys to input the desired value and choose the unit. X1, XK,
XM respectively represent 1, 1000, 1000,000. The waveform points range is 2 -
1000,000.
(3) Set the interpolation: Press F2 to switch between On/Off. If you choose On, the
points will be connected with beelines; otherwise, the voltages between two
consecutive points will not change, and the waveform looks like a step-up one.
(4) Edit the waveform points: Press F3 to enter the operation menu.
Press F1 to choose "Points", input the number of the point to be edited.

Press F2 to choose "Voltage", input the voltage for the current point.

Repeat the step above, set all the points to your needs.

5.Front Panel Operation
/ direction key to choose the desired waveform. E.g.
Instruction
Create a new waveform.
Select the waveform stored in internal storage (FLASH) or U disk
(USBDEVICE).
Edit the stored waveform.
19
→Editable Wform →Create Wform.
to select "Wform Points", turn the