or press the number keys to input the desired value and choose the unit.
The Edge Time range is 20ns - 1ms, and cannot exceed 50% of the Pulse Width.
Parameter bar 1
Input box
Edge time
Figure 5-9: Set the Edge Time of Pulse signal
Note:
The rising time and falling time of Pulse signal should have the same value by default.
To Output Noise Signals
The noise signal which the generator output is white noise. Press
user interface of Noise signal, the Noise waveform parameters can be set by operating
the Noise setting menu on the right.
The parameters of Noise waveform are: Amplitude/High Level, Offset/Low Level. You can
operate the menu by using the menu selection buttons on the right.
To set the Amplitude/High Level, Offset/Low Level, please refer to "To Output Sine
Signals" on P11.
Load
Amplitude
Offset
Parameter bar 2
Figure 5-10: The User Interface of Noise Signal
5.Front Panel Operation
Current parameter
Edge time
Noise
waveform
17
button to call the
Current signal
Setting menu of
Noise signal