User Interface - Owon AG4081 User Manual

⑤ RS232 port
⑥ Power socket
⑦ Fuse
⑧ Power switch
⑨ LAN port
⑩ USB Host port
⑪ USB Device port
⑫ Digital output

User Interface

①
②
③
④
⑤
⑥
⑦
Figure 4-3 User interface (take Sine for instance)
① Parameter bar 1, display parameters and edit the focused parameter
② Load, High Z represents high resistance
③ Frequency/period, depends on the highlighted menu item on the right
④ Amplitude/high level, depends on the highlighted menu item on the right
⑤ Offset/low level, depends on the highlighted menu item on the right
⑥ Display current waveform
⑦ Parameter bar 2, display parameters and edit the focused parameter
4.Quick Start
Through this interface, the generator can be connected to
a PC and controlled via PC software.
AC input connector
The rating is
100 - 120 V 250 V, F1AL
220 - 240 V 250 V, F0.5AL
Switch between 110V and 220V.
Through this interface, the generator can be connected to
your local network and controlled via PC software.
Connect as a "host device" with an external USB device,
such as connect a USB disk to the instrument.
Connect as a "slave device" with an external device, such
as connected to a PC and controlled via PC software.
Connect the generator with the logic signal output module
(optional). Then, configure specific sequence digital signal
in the generator and output the signal through the digital
module.
7
⑧
⑨
⑩