Table of Contents
Advertisement
4 Product Installation
※ 4.2 Mounting the Inverter (standard bracket)
4.2.1 Wall bracket installation
Dimensions of wall bracket, see Figure 4-4:
150mm
Figure 4-4 Dimensions of wall bracket
① Use the wall bracket as the template to mark the position of 5 holes on the wall. See Fig-
ure 4-5 for details:
Figure 4-5 Mark the hole position
② Use an electrical driller with 10mm diameter bit to drill 5 holes on the wall and make
sure hole depth is 80mm.
24
300mm
150mm
150mm
Before drilling, make sure to avoid the buried water tube and electric wires in the wall to
avoid danger.
Warning
③ Insert the expansion tubes into the holes and tighten them, then fix the bracket onto
the wall with expansion screws by using a cross screwdriver, as shown in Figure 4-6:
Figure 4-6 Fix the wall bracket
4.2.2 Mounting the inverter
Lift up the inverter with both hands, hang the back rail on the fixed wall bracket carefully,
see Figure 4-7 for details:
Figure 4-7 Mounting the inverter
4 Product Installation
25
Advertisement
Table of Contents
