Maintenance Schedule; Troubleshooting; 6.8. Recommended Oils - Sealey SAC20030B Quick Start Manual

c) Check all tube fittings and electrical connections.
d) Inspect pressure tank inside and out for damage or corrosion.
6.7.

MAINTENANCE SCHEDULE

Maintenance Operations
Drain condensation
Check oil level
Clean intake filter
Check for oil leaks
Replace oil
Check cut-out
General cleaning of
compressor
Replace air filter
Check tube fittings and
electrical connections
Internal & external
inspection of tank
Check and adjust belt
tension
6.8. RECOMMENDED OILS
Synthetic oil suitable for temperatures ranging from -5°C to 45°C: Viscosity 5W50. We DO NOT recommend using mineral oil in
these compressors.
Part No. Qty. Description
FSO1 1ltr x 12 Compressor oil fully synthetic
FSO1S 1ltr x 1 Compressor oil fully synthetic
FSO5 5ltr x 1 Compressor oil fully synthetic
IMPORTANT WARNING - Air contaminants taken into the compressor will affect optimum performance. Example: Body filler
‰
dust or paint overspray will clog the pump intake filter and may cause internal damage to pump/motor components. Please note
that any parts damaged by any type of contamination will not be covered by warranty.
7. TROUBLE SHOOTING
Fault
Pressure drop in the
tank.
Pressure switch
valve leaks when
compressor is idle.
Compressor stops
and does not restart.
Compressor does
not stop at max
pressure.
Compressor does
not reach max
pressure.
Compressor noisy
with metallic knock.
© Jack Sealey Limited
Weekly 50hrs 100hrs
•
•
•
•
•
Cause Remedy
Air leaks at Run compressor to max.
connections. pressure, switch off.
Brush soap solution over
connections and look for
bubbles. Tighten connections
showing leaks. If problem
persists contact Authorised
Service Agent.
Non-return valve seal Discharge all tank pressure.
defective. Referring to fig.4, and fig.9,
unscrew valve cap 'A'. Clean
rubber disc 'B' and its seat.
Refit all parts accurately.
Power failure. Check electricity supply and
fuse.
Motor failure. Contact Authorised Service
Agent.
Pressure switch fault. Contact Authorised Service
Agent.
Filter clogged. Replace filter element.
Head gasket or valve Contact Authorised Service
fault. Agent.
Low oil level. Turn off and top up oil
Bearing or piston immediately.
damage. Contact Authorised Service
Agent.
Original Language Version
400 hrs
•
•
•
•
•
•
fig.9
SAC20030B, SAC15030B Issue: 1 08/03/21