Advertisement
17. Attach outlet port and filter L-braces to blower
housing with outlet gasket between outlet
port and housing, as shown in Figure 15,
using (8)
⁄
"-18 x 1" hex bolts, (16)
5
16
washers, and (8)
5
Note: One brace attaches directly to hous-
ing with the following extra hardware:
(2)
⁄
"-18 x 1" hex bolts, (4)
5
16
and (2)
⁄
"-18 hex nuts.
5
16
Figure 15. Outlet port and filter L-braces
installed.
18. Mount filter to L-braces with brace gaskets
between them, as shown in Figure 16, using
(4)
⁄
"-18 x
⁄
" hex bolts and
5
3
16
4
washers.
Brace Gasket Here
Filter
Figure 16. Mounting filter to braces.
Model H7509Z (Mfd. Since 01/21)
⁄
" flat
5
16
⁄
"-18 hex nuts.
16
⁄
" flat washers,
5
16
Outlet Port
x 10
L-Braces
⁄
" fender
5
16
x 4
19. Apply 3 x 15mm foam tape rolls to lips of
outlet port, canister adapter, and both ends
of muffler, as shown in Figure 17.
Foam
Tape
Figure 17. Foam tape applied to upper
components.
20. Attach 8" x 5" gray flexible hose between
canister adapter and muffler with (2) 8" hose
clamps, then attach 8" x 20" gray flexible
hose between muffler and outlet port with (2)
8" hose clamps (see Figure 18).
Note: It may be necessary to reposition can-
ister L-braces down one bolt hole or shorten
length of longer piece of flexible hose to
accommodate bend in hose.
Muffler
Figure 18. Muffler properly positioned between
two gray flexible hoses.
21. Apply 3 x 6 x 300mm foam tape to mating
surface of cyclone vacuum port.
Foam
Tape
-7-
Advertisement
