Advertisement
5.
Place motor/blower housing on a large piece
of cardboard to prevent scratches.
6.
Attach intake cylinder to bottom of housing,
as shown in Figure 7, with (4)
hex bolts and
⁄
" flat washers.
5
16
Note: Because this part of dust collector is
not accessible after assembly is complete,
consider using thread locker on bolts that
secure intake cylinder to motor/blower hous-
ing assembly to ensure that fasteners will not
come loose with vibration.
Intake
Cylinder
x 4
Figure 7. Intake cylinder attached to the bottom
of motor housing.
7.
Attach cyclone funnel to intake barrel with
barrel gasket between them with (12)
x 1" hex bolts, (24)
⁄
"-18 hex nuts (see Figure 8).
5
16
x 12
Figure 8. Cyclone funnel attached to intake
barrel.
Model H7509Z (Mfd. Since 01/21)
⁄
"-18 x
5
16
Motor/Blower
Housing
⁄
"-18
5
16
⁄
" flat washers, and (12)
5
16
Cyclone
Funnel
Barrel
Gasket
We strongly recommend using a general-
purpose silicone sealant on all mating
⁄
"
3
surfaces during assembly process. For
4
those components assembled with a rubber
gasket between them, apply sealant evenly
on both sides of gasket before assembly.
Note: At places where you see three holes
close together, only use center hole for this
step. The two outside holes will be used in
the next step.
8.
Attach (4) Model H7509Z collector mounting
brackets to intake assembly, as shown in
Figure 9, with (8)
⁄
" flat washers, and (8)
5
16
x 8
Figure 9. Collector mounting brackets and
9.
Place large piece of cardboard on ground to
prevent scraping parts on bare floor during
next steps.
10. With help of another person, lay stand assem-
bly on its side on cardboard and slide collec-
tor assembly into stand assembly, as shown
in Figure 10.
⁄
"-18 x 1" hex bolts, (16)
5
16
⁄
"-18 hex nuts.
5
16
securing fasteners.
-5-
Advertisement
