Advertisement
Assembly
Before beginning the assembly process, refer to
Needed for Setup in this manual and Inventory
on Page 3 of the Model G0441 Manual Update
and gather all listed items.
IMPORTANT: Use these steps instead of those
listed in the Model G0441 Manual Update to
assemble your dust collector to the H7509Z stand.
Straining injury may occur
from
stand/collector parts. To
reduce this risk, get help
from other people and use
lifting equipment rated for
weight of stand/collector.
To assemble dust collector on stand:
1.
Connect upper stand legs with lower bracket
braces with (16)
5
⁄
" flat washers, and
5
16
Figure 3).
Note: Be sure to build frame using bolt holes
indicated in Figures 3–4 and 14. Machine
will not fit correctly on frame if wrong holes
are used and you will need to rebuild frame.
Figure 3. Initial assembly of upper stand legs
connected to lower bracket braces.
Note: Only finger tighten hardware in Steps
1–2 for now.
-4-
HEAVY LIFT!
improperly
lifting
⁄
"-18 x
⁄
" carriage bolts,
3
16
4
⁄
"-18 hex nuts (see
5
16
Upper
Stand
Leg
x 16
Lower Bracket
Brace
2.
Attach upper stand braces to top of assembly
from Step 1, with (16)
bolts,
⁄
" flat washers, and
5
16
(see Figure 4).
Figure 4. Upper braces attached to stand
assembly.
3.
Square stand, as shown in Figure 5, then
tighten all hardware.
Figure 5. Example of squaring stand assembly
before tightening stand hardware.
4.
Place intake cylinder on floor and apply 3 x
6 x 1800mm foam tape to intake cylinder top
rim, between mounting holes and inside edge
(see Figure 6).
Foam Tape
Figure 6. Foam tape applied to intake cylinder
Model H7509Z (Mfd. Since 01/21)
⁄
"-18 x
⁄
" carriage
5
3
16
4
⁄
"-18 hex nuts
5
16
x 16
Upper
Stand
Brace
rim.
Advertisement
