Advertisement
41. Secure vacuum hose inside upper and lower
stand legs with (2) vacuum hose clips (see
Figure 32).
Figure 32. Securing vacuum hose to stand legs.
42. Remove securing Phillips head screw and
open power junction box on Model G0441
switch bracket (see Figure 33).
Power
Junction Box
Figure 33. Location of securing screw on power
junction box.
43. Remove hex nuts, external tooth washers,
and Phillips head screw securing ground wire
to switch bracket (see Figure 34).
44. Remove strain relief shown in Figure 34.
Model H7509Z (Mfd. Since 01/21)
45. Remove (4) Phillips head screws, flat wash-
ers, and hex nuts shown in Figure 34 to
remove junction box from switch bracket.
Strain Relief
x 4
Figure 34. Inside power junction box (shown
with power conduit attached for clarity).
46. Install power junction box to left side of Model
H7509Z switch box base panel as it was
attached to G0441 switch bracket (see Steps
43–45).
47. Close and secure power junction box.
48. Remove securing Phillips head screw and
washer and open magnetic switch box on
Model G0441 switch bracket (see Figure 35).
Figure 35. Location of securing fasteners on
magnetic switch box.
-11-
Advertisement
