Advertisement
49. Remove (4) Phillips head screws, flat wash-
ers, and hex nuts shown in Figure 36 to
remove magnetic switch from switch bracket.
Figure 36. Inside magnetic switch box.
50. Install magnetic switch box to right side of
Model H7509Z switch box base panel as it
was attached to G0441 switch bracket (see
Step 49).
51. Close and secure magnetic switch box.
52. Mount switch box base panel on stand, as
shown in Figure 37, with (3)
bolts, (6)
⁄
" flat washers, and (3)
3
8
nuts.
-12-
x 4
⁄
"-16 x
⁄
" hex
3
3
8
4
⁄
"-16 hex
3
8
Note: Hand-held remote control uses IR
(infrared) to communicate with control box
receiver port, and must have direct line-of-
sight to switch box face. Locate control box
with this in mind.
Figure 37. Switch mounted to stand.
53. Slip canister collection bag around opening
under canister filter and secure with metal
bag clamp (see Figure 38).
Bag Clamp
Collection Bag
Figure 38. Canister collection bag secured to
filter.
54. Refer to G0441 Manual for Test Run and
Operation procedures beginning on Page 25.
Note: Remaining 8" hose clamp is for secur-
ing woodworking machine dust hose to inlet
port.
Model H7509Z (Mfd. Since 01/21)
x 3
Advertisement
