Advertisement
11. Fasten collector assembly to stand with (8)
⁄
"-18 x
⁄
" carriage bolts,
5
3
16
4
and
⁄
"-18 hex nuts, as shown in Figure 10.
5
16
x 8
Figure 10. Collector assembly fastened to stand.
12. Lift assembly upright and rotate it so inlet/
outlet directions are suitable for your shop.
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this
risk, use a forklift (or other
lifting equipment) rated for
weight of this machine.
13. Place remaining barrel gasket on top of
intake barrel.
14. Using two punches or Phillips screwdrivers,
align mounting holes, as shown in Figure 11,
and lower assembly onto intake barrel.
Barrel Gasket
Here
Figure 11. Aligning mounting holes.
-6-
⁄
" flat washers,
5
16
HEAVY LIFT!
Note: In next step, when installing two bolts
above intake port, use duct tape on bottom of
your wrench, as shown in Figure 12, to hold
bolts in place. This will enable you to start the
bolts more easily.
Figure 12. Using tape on wrench in tight spot.
15. Attach assembly to intake barrel, as shown
in Figure 13, with (12)
and
⁄
" flat washers.
5
16
Figure 13. Securing blower on intake barrel.
16. Using forklift or assistants, raise assembly
and attach lower stand legs to upper stand
legs, as shown in Figure 14, with (16)
x
⁄
" carriage bolts,
3
4
⁄
"-18 hex nuts.
5
16
x 16
Figure 14. Attaching lower legs to the initial
stand assembly.
Model H7509Z (Mfd. Since 01/21)
⁄
"-18 x
⁄
" hex bolts
5
3
16
4
x 12
⁄
"-18
5
16
⁄
" flat washers, and
5
16
Advertisement
