Table of Contents
Advertisement
For all other models, use the following instructions to route the cables:
A. Insert the Ethernet adapter cable and optional ICE Heading Sensor extension
cable connectors into the correct slots in your cable tray. Each slot is shaped
specifically for each connector, and insertion should be easy. Route the cables
using the grooves in the tray. Refer to your ICE HELIX Shuttle Installation
Guide for cable tray installation instructions.
B. Route the Ethernet adapter cable through one of the side grommets on the
back battery cover of your ICE HELIX Shuttle. Connect it to the Ethernet
extension cable. Making this connection outside of the shuttle will allow for
quick-disconnect.
C. Route the optional Heading Sensor extension cable through one of the side
grommets on the back battery cover of your ICE HELIX Shuttle. Connect it to
the Heading Sensor cable. Making this connection outside of the shuttle will
allow for quick-disconnect.
4. Cable Management: Wrap excess cable using the molded hooks on the MEGA
Live ICE adapter base.
MEGA Live ICE Transducer and Base
HELIX G3N 8, 9, 10, 12 Cable Tray
transducer
COM (communications)
pin
Ethernet
HELIX G4N 8, 9, 10, 12, 15 Cable Tray
transducer
COM (communications)
pin
Ethernet
power
temp/speed
power
NMEA 2000
18
pin
pin
Advertisement
Table of Contents
