Table of Contents
Advertisement
Operation Manual / TPL65VA32 / VA33
4 Operation / 4.4 Speed measurement
4.4.2 Assembly
© Copyright 2020 . All rights reserved.
If the speed sensor is not fitted on the turbocharger, the following pro-
cedure must be adopted to fit it:
Engine and turbocharger are not running.
w
The turbocharger lubricating system is switched off.
w
Remove screw plug (42047) from bearing casing.
u
NOTICE
Part position
The position of the screw plug for measuring the speed is marked "n"
on the bearing casing.
Screw in speed sensor (86505) as far as it will go and tighten to
u
torque specified in table. (See chapter Table of tightening torques.)
Connect speed sensor using cable connector (86515).
u
HZTL2464_EN
Rev.E
March 2020
Advertisement
Table of Contents
