Table of Contents
Advertisement
Operation Manual / TPL65VA32 / VA33
2 Safety / 2.6 Safe operation and maintenance
© Copyright 2020 . All rights reserved.
Electric tools must be solidly earthed, and connecting cables may not
u
be damaged.
Keep the workplace clean, clear away loose objects and remove
u
obstacles on the floor.
Keep the floor, equipment and the turbocharger clean.
u
Have oil binding materials ready at hand and keep oil catch pans
u
ready or in position
Eliminate leaks.
u
Keep fire-protection materials and fire-extinguishing equipment
u
ready.
Welding work close to the turbocharger
If welding work is being carried out in the vicinity of the turbocharger,
u
cover the filter silencer so that the filter mat is not damaged.
Remove combustible objects and substances out of the range of fly-
u
ing sparks.
Cover all connections on the turbocharger so that no foreign objects
u
can get into the turbocharger.
Wear personal protective equipment (PPE) for welding operations.
u
Safety during start-up / commissioning and operation
Before starting work, carry out visual inspection of working area.
u
Remove any obstacles and objects lying around.
u
Before start-up / commissioning, check all pipes from and to tur-
u
bocharger for damage and leaks.
Don't work in any way that could impair safety when working on tur-
u
bocharger.
After about every 12 hours of operation or at least once a day, inspect
u
turbocharger for visible damage and defects.
Immediately report any damage or changes in operational perform-
u
ance to person responsible.
If damage is discovered, immediately shut down turbocharger and se-
u
cure it against inadvertent or unauthorized use.
When switching on auxiliary power sources (hydraulics, pneumatics,
u
electricity, water), keep an eye open for any hazards resulting from
supplying these power sources.
Safety during cleaning
If cleaning agents or solvents are used for cleaning, the corresponding
material safety data sheet and the safety instructions in section "Haz-
ards due to operating and auxiliary materials" must be observed.
HZTL2464_EN
Rev.E
March 2020
Advertisement
Table of Contents
