Security Menu - Setting The Security Features - Fujitsu Lifebook P1510D Bios Manual

SECURITY MENU - SETTING THE SECURITY FEATURES

The Security menu allows you to set up the data security
features of your notebook to fit your operating needs and
to view the current data security configuration. Follow
the instructions for Navigating Through the Setup Utility
to make any changes.
The following tables show the names of the menu fields
for the Security menu and its submenus, all the options
for each field, the default settings and a description of the
field's function and any special information needed to
help understand the field's use. The default condition is
no passwords required and no write protection.
If you set a password, write it down and
keep it in a safe place. If you forget the
password you will have to contact your
support representative to regain access to
your secured functions and data.
Main
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Minimum User Password Length
Password on Boot:
On Automatic Wake up:
KB Lock on Resume:
Boot from Removable Media:
Flash Write:
Hard Disk Security
Owner Information
Security Chip Setting
F1 Help
ESC Exit
PhoenixBIOS Setup Utility
Advanced Security
Select Item -/Space
Select Menu
Figure 11. Security Menu
Boot Info Exit
Clear
Clear
[Enter]
[Enter]
[0]
[Disabled]
[Disabled]
[Disabled]
[All]
[Enabled]
Change Values
Enter Select Sub-Menu
S e c u r i t y M e n u
• If you make an error when re-entering
the password a [Warning] will be
displayed on the screen. To try again,
press the Enter key and then retype the
password. Press the Esc key to abort the
password setting process.
• Entering a password incorrectly three
times in a row will cause the keyboard
and mouse to be locked out and the
warning [System Disabled] to be
displayed. If this happens, restart the
computer by turning off and on the
power with the power switch and use
the correct password on reboot.
• If the Password on Resume is Enabled
and the Password on Boot is Disabled
you will not have to type your password
upon resuming the system from the
Suspend or Save-to-Disk modes. Power
Management Security will work only if
Password on Boot is enabled.
Item Specific Help
Press <Enter> key to
set Supervisor Password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
F9 Setup Defaults
F10 Save and Exit
17