Exit Menu - Leaving The Setup Utility - Fujitsu Lifebook P1510D Bios Manual

EXIT MENU - LEAVING THE SETUP UTILITY

The Exit Menu is used to leave the setup utility. Follow the instructions for
make any changes. The table shows the names of the menu fields for the Exit menu and a description of the field's func-
tion and any special information needed to help understand the field's use.
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Save Changes and Power Off
F1
ESC
Table 18: Fields, Options and Defaults for the Exit Menu
Menu Field Description
Exit Saving Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory and then
Changes exit the setup utility. A confirmation message Save Configuration changes and exit now? [Yes] [No] will be displayed.
Exit Discarding Selecting Exit Discarding Changes and Exit will exit the setup utility immediately without writing to the BIOS memory
Changes and without displaying a confirmation screen. When the BIOS recognizes this selection it will load the operating system
and begin operation.
Load Setup Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the message
Defaults Load default configuration now? [Yes] [No]. When confirmed the setup utility will return to the Exit Menu. To return to
another menu follow the directions in the
Discard Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message Load previ-
Changes ous configuration now? [Yes] [No] will be displayed. When confirmed the setup utility will return to the Exit menu. To
return to another menu, follow the directions in the
Save Changes Selecting Save Changes will cause the new settings in all menus to be written to the BIOS memory. The message Save
configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup utility will return to the Exit
menu. To return to another menu, follow the directions in the
Save Changes Selecting Save Changes and Power Off will cause the new settings in all menus to be written to the BIOS memory, then
power the system off. The message Save configuration changes now and power off? [Yes] [No]
and Power Off
will be displayed. When confirmed, the setup utility shut down the system.
PhoenixBIOS Setup Utility
Main Advanced
Help Select Item
Exit Select Menu
Security Power Savings
-/Space Change Values
Enter Select Sub-Menu
Figure 18. Exit Menu
Navigating through the Setup Utility
Navigating through the Setup Utility
Navigating through the Setup Utility
E x i t M e n u
Navigating through the Setup Utility
Boot Exit
Item Specific Help
Exit System Setup and
save your changes to
CMOS.
F9 Setup Defaults
F10 Save and Exit
section.
section.
to
section.
25