Texas Instruments TPS51113 User Manual

Texas Instruments TPS51113 User Manual

Buck controller evaluation module

Advertisement

Quick Links

www.ti.com
User's Guide
TPS51113 Buck Controller Evaluation Module User's
Guide
1
Introduction.............................................................................................................................................................................2
2 Description..............................................................................................................................................................................
3 Typical Applications...............................................................................................................................................................
4
Features...................................................................................................................................................................................2
5 Electrical Performance Specifications.................................................................................................................................
6
Schematic................................................................................................................................................................................3
Setup................................................................................................................................................................................4
8 Test Procedure........................................................................................................................................................................
9 Performance Data and Typical Characteristic Curves........................................................................................................
10 EVM Assembly Drawing and PCB Layout........................................................................................................................
11 List of Materials...................................................................................................................................................................
12
References...........................................................................................................................................................................11
History..................................................................................................................................................................11
Trademarks
All trademarks are the property of their respective owners.
SLUU359A - APRIL 2009 - REVISED FEBRUARY 2022
Submit Document Feedback

Table of Contents

Copyright © 2022 Texas Instruments Incorporated
TPS51113 Buck Controller Evaluation Module User's Guide
Table of Contents
2
2
2
6
7
10
11
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TPS51113 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Texas Instruments TPS51113

  • Page 1: Table Of Contents

    11 List of Materials................................... References...................................11 13 Revision History..................................11 Trademarks All trademarks are the property of their respective owners. SLUU359A – APRIL 2009 – REVISED FEBRUARY 2022 TPS51113 Buck Controller Evaluation Module User's Guide Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 2: Introduction

    1 Introduction The TPS51113-EVM evaluation module (EVM), is a high efficiency single phase synchronous buck converter providing a fixed 1.2-V output at up to 25 A from a 12-V input bus. The EVM uses the TPS51113 synchronous buck controller. 2 Description The TPS51113-EVM is designed to use a regulated 12-V (8 V to 14 V) bus to produce a high current, regulated 1.2-V output at up to 25 A of the load current.
  • Page 3: Schematic

    Schematic 6 Schematic Figure 6-1. TPS51113-EVM Schematic Diagram SLUU359A – APRIL 2009 – REVISED FEBRUARY 2022 TPS51113 Buck Controller Evaluation Module User's Guide Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 4: Test Setup

    (2-feet input, 2-feet return). For J2 to LOAD, the minimum recommended wire size is 2 × AWG #14, with the total length of wire less than four feet (2-feet output, 2-feet return). TPS51113 Buck Controller Evaluation Module User's Guide SLUU359A – APRIL 2009 – REVISED FEBRUARY 2022 Submit Document Feedback Copyright ©...
  • Page 5 7.2 Recommended Test Setup Figure 7-2 is the recommended test set up to evaluate the TPS51113-EVM. Working at an ESD workstation, make sure that any wrist straps, bootstraps, or mats are connected referencing the user to earth ground before power is applied to the EVM.
  • Page 6: Test Procedure

    9. Decrease V to 0 V. 8.2 Control Loop Gain and Phase Measurement Procedure The TPS51113-EVM contains a 20-Ω series resistor in the feedback loop for loop response analysis. 1. Set up the EVM as described in Section 8.1 Figure 7-2.
  • Page 7: Performance Data And Typical Characteristic Curves

    Performance Data and Typical Characteristic Curves 9 Performance Data and Typical Characteristic Curves Figure 9-1 through Figure 9-8 present typical performance curves for the TPS51113-EVM. EFFICIENCY OUTPUT VOLTAGE OUTPUT CURRENT OUTPUT CURRENT 1.200 1.198 1.196 1.194 Input Input Voltage (V) Voltage (V) 1.192...
  • Page 8 RippleX X Figure 9-6. Enable Turn-OffX X Figure 9-7. Enable Turn-OnX X Figure 9-8. Switching Node TPS51113 Buck Controller Evaluation Module User's Guide SLUU359A – APRIL 2009 – REVISED FEBRUARY 2022 Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 9 Performance Data and Typical Characteristic Curves SLUU359A – APRIL 2009 – REVISED FEBRUARY 2022 TPS51113 Buck Controller Evaluation Module User's Guide Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 10: Evm Assembly Drawing And Pcb Layout

    10 EVM Assembly Drawing and PCB Layout Figure 10-1 through Figure 10-6 show the design of the TPS51113-EVM printed circuit board. The EVM has been designed using four layers on a 2-oz. copper circuit board. EXAS NSTRUMENTS Figure 10-1. Top Layer Assembly Drawing (Top Figure 10-2.
  • Page 11: List Of Materials

    Updated the numbering format for tables, figures, and cross-references throughout the document....2 • Updated the user's guide title..........................SLUU359A – APRIL 2009 – REVISED FEBRUARY 2022 TPS51113 Buck Controller Evaluation Module User's Guide Submit Document Feedback Copyright © 2022 Texas Instruments Incorporated...
  • Page 12 STANDARD TERMS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, and/or documentation which may be provided together or separately (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms set forth herein.
  • Page 13 www.ti.com Regulatory Notices: 3.1 United States 3.1.1 Notice applicable to EVMs not FCC-Approved: FCC NOTICE: This kit is designed to allow product developers to evaluate electronic components, circuitry, or software associated with the kit to determine whether to incorporate such items in a finished product and software developers to write software applications for use with the end product.
  • Page 14 www.ti.com Concernant les EVMs avec antennes détachables Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à...
  • Page 15 www.ti.com EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS. 4.2 User must read and apply the user guide and other available documentation provided by TI regarding the EVM prior to handling or using the EVM, including without limitation any warning or restriction notices.
  • Page 16 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2019, Texas Instruments Incorporated...
  • Page 17 TI products. TI’s provision of these resources does not expand or otherwise alter TI’s applicable warranties or warranty disclaimers for TI products. TI objects to and rejects any additional or different terms you may have proposed. IMPORTANT NOTICE Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2022, Texas Instruments Incorporated...

Table of Contents