Table of Contents
Advertisement
6.1.4
6.1.4
Pause
Pause
alarm:
alarm:
6.1.4
6.1.4 Pause
Pause alarm:
alarm:
A
Alarm includes the alarm of measure data's going beyond the limits, the alarm of low-power,
and the alarm of finger out.
B
In the measuring interface, if the alarm function is on, during the period of alarming, alarm can
be suspended by short pressing the button, but the function will be renewed in about 60 seconds.
C If you want to turn off the alarm for good, you should enter the menu for operation.
6.1.5
6.1.5
6.1.5
6.1.5 Menu
Menu operations:
Menu
Menu
operations:
operations:
operations:
In the measuring interface,the display direction can be changed by pressing the button with a short
push (click). There are four modes of data display that can be viewed.
Press the button with a prolonged push (1 second) to enter the Settings Menu Interface (see Figure
5 ).Please
Please
Please
Note:
Note:
Note: When the display direction is lengthways, you can not enter the main menu
Please Note:
interface.Click the power button to switch to landscape orientation.
The user can setup the following content in the Settings Menu:Backlight Brightness, Alarm
setting,ID setting, data storage (Record), turning on/off Bluetooth.The specific operation methods
are as follows:
Please note in the Settings Menu:
CLICK
CLICK
CLICK = short push of button and PRESS
CLICK
A A A A Backlight
Backlight
Backlight
adjustment
adjustment
Backlight adjustment
adjustment
In the main menu interface, click the button to select "Brightness", Press the power button and hold
to adjust the backlight brightness.
B B B B Alarm
Alarm
Alarm
setting
setting
Alarm setting
setting
In the main menu interface, click the power button to select "Alarm", Press the power button (1sec)
to enter the alarm setting interface as shown in Figure 6:
a) a) a) a) Adjust
Adjust
ing
the
high
Adjusting
Adjust
ing
ing the
the
the high
high and
high
Click button to change the position of menu selection bar,and press button to set menu item.Move
the selection bar to "Dir" ,and press button to choose value adjusting direction : up or down.By
pressing button operation,the user could adjust the value of SpO
low limit (SPO
ALM LO), Pulse rate high limit (PR ALM HI), Pulse rate low limit (PR ALM
2
LO).The alarm low limit can't be beyond the alarm high limit.The SpO
0%~100%,the pulse rate alarm range is 0bpm~254bpm.
PRESS
PRESS = prolonged push of power button (1sec)
PRESS
Figure 5 Main Menu Interface
and
low
limit
limits s s s of of of of alarm
alarm
alarms s s s
and
and low
low limit
low
limit
alarm
high limit (SPO
2
7
ALM HI), SpO
2
2
alarm range is
2
Advertisement
Table of Contents
