Operating Mode Description - INFOSEC C3 MPPT User Manual

3-6. Operating Mode Description

Operation mode
Standby mode / Power
saving mode
Note:
*Standby mode: The
inverter is not switched
on yet but at this time,
the inverter can charge
the battery without the
AC output.
*Power saving mode: If
enabled, the output of
C3 MPPT / C3+ MPPT
will be off when the
connected load is low
or not detected.
Fault mode
Note:
*Fault mode: Errors are
caused by an internal
circuit error or an
external reason such
as overheating, output
short-circuit, etc.
Fault mode
Note:
*Fault mode: Errors are
caused by an internal
circuit error or external
reasons such as over
temperature, output
short-circuit and so on.
Line Mode
Battery Mode
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 06 15 AA 59 203 33
Description
No output is supplied
by the unit but it can
still charge batteries.
Photovoltaic energy
and utility can charge
the batteries.
The utility can power
loads when the unit
starts without battery.
(Only available in
4K/5K models with
single operation)
The unit will provide the
output power from the
mains. It will also
charge the battery in
line mode.
The unit will provide the
LCD display
Charging by utility.
Charging by photovoltaic energy.
No charging.
Charging by utility. (Only available in 1K/2K/3K
models)
Charging by PV energy.
No charging.
Power from utility
Charging by photovoltaic energy
Charging by utility.
Power from battery and photovoltaic energy.
25