Pc Cards; Installing/Removing Pc Cards - Fujitsu LifeBook P7120 User Manual

P7010.book Page 37 Wednesday, June 1, 2005 3:39 PM
PC Card Slot
PC Card

PC Cards

Your Fujitsu LifeBook notebook supports Type I and II
PC Cards, which can perform a variety of functions.
Some available PC Cards:
Fax/data modem cards
■
Local area network (LAN) cards
■
IDE solid-state disk cards
■
■ SCSI cards
Wireless LAN cards
■
Other PC Cards that conform to PCMCIA 2.1 or
■
CardBus standards
For further information, refer to the instructions
supplied with your PC Card.
INSTALLING PC CARDS
PC Cards are installed in the PC Card slot. To install a
PC Card, follow these easy steps: (Figure 4-8)
I nstalling or removing a PC Card during
■
your LifeBook notebook's shutdown or
bootup process may damage the card
and/or your notebook.
■ Do not insert a PC Card into a slot if
there is water or any other substance on
the card as you may permanently dam-
age the card, your LifeBook notebook,
or both.
1. See your PC Card manual for specific instructions
on the installation of your card. Some PC Cards may
require your notebook to be Off while installing
them.
2. Make sure there is no PC Card currently in the slot.
If there is, see Removing PC Cards.
3. Insert your PC Card into the slot, with the product
label facing up.
U s e r I n s t a l l a b l e F e a t u r e s
Eject Button
Figure 4-8 Installing/Removing PC Cards
4. Push the card into the slot firmly until it is seated
in the opening. You will hear a click and the Eject
button will pop away from your notebook.
REMOVING PC CARDS
To remove a PC Card, follow these easy steps:
Windows has a shutdown procedure for
PC Cards that must be followed before
removing a card. (Please review your oper-
ating system manual for the correct proce-
dure).
1. See your PC Card manual for specific instructions
on removing your card. Some PC Cards may require
your notebook to be in Suspend Mode or Off while
removing them.
If the dialog box states that the device
cannot be removed, you must save all of
your open files, close any open applica-
tions and shut down your notebook.
2. Push the Eject button in until it is flush with the
notebook. This will push the PC Card slightly out of
the slot allowing you to remove the card.
If the PC Card has an external connector
and cable, do not pull the cable when
removing the card.
37