Idis DirectIP DR-2304P Quick Manual page 9

Camera Registration
Once Network Setup Wizard is complete, live mode screen
appears. While in live mode, right-click on the mouse and
select Camera Registration to run the Camera Registration
mode. It allows you to scan for the cameras connected to
the NVR.
1
3
Camera Scan Button
1
Camera List Area
3
Apply/Cancel
5
Buttons
Camera Scan Button
Use this button to scan for and register cameras.
Pressing the Scan button displays the following submenu:
● Rescan: Scan for DirectIP™ cameras that were not
scanned automatically.
● Go To Camera: Moves the focus automatically to the
camera using MAC address of camera in the camera list.
● Screen Auto. Assign: Assigns the detected cameras on
the video display area.
● Camera list: By using the camera information file, .csv,
the user can register the cameras easily.
● Scan Refresh Interval: Configures the refesh interval
to scan the camera. If the interval is short, camera scan
results are refreshed more frequently. However, if the
interval is long, it is advantageous to scan cameras on a
wide network.
● Third Party Scan: Used to manually scan for third-party
cameras that cannot be recognized by the auto scan
feature.
- Protocol: Select the protocol used by the camera (or
video encoder) you wish to search for.
Even if the network device uses a protocol
supported by the NVR, the device itself may not
be visible for scanning and registration by the
NVR. For more information about supported
network devices and models, contact your
retailer.
2
4
5
Camera View
2
Buttons
Video Display Area
4
- Mode: Select the scan mode.
- Advanced Setup: If the camera is networked but
not scanned, use this setup. This setup allows you to
change the network setting of the NVR's VIDEO IN
port which is camera's network environment. Check
the camera's network setting first before you use this
setup. Make sure that this setting does not conflict
with the WAN setting. For more information on the
WAN setting.
1
Select Scan to commence scanning.
2
Select a camera from the scan list and then select Add
Camera. The Device Login window will appear.
3
Enter a User ID and a Password for the selected
camera.
Camera View Buttons
● ALIGNMENT
Button: Realigns camera screens
displayed on the video display area in the order of Video
In port connections.
● RESET
Button: Refreshes the video display area and
the camera list.
● TOOL
Button: Displays netcwork camera tool
window and changes the camera protocol.
Camera List Area
Following options can be accessed by right-clicking on a
camera list entry:
● Add/Remove Camera: Adds or removes the selected
camera. The Add Camera option is inactive if the camera
has already been added to the screen.
● Authentication: Enter the necessary camera login info.
This option is inactive for DirectIP™ cameras because
they do not require logins.
Video Display Area
Left-click on the video display area to toggle between split
screen and single screen modes.
Drag the camera screens around to rearrange them.
9