Advertisement
d. Place the SMR right side up into the normal operating position. Slide the two ¼ inch nuts
into the top two slots in the SMR. (Refer to figure three). Install the washers on both
screws on the Redi-Rack, and install the Redi-Rack onto the top of the SMR. (Refer to
figure four). Tighten the screws.
e. Plug in the TS-15 Plug in the Universal Power Cord into the keyed port on the back of the
SMR Plug the other end into the TS-15 Handpiece.
f.
The Handpiece receptacle shown in figure five is the Universal Power Cord (Slowly turn
the connector until it drops into place in the receptable. Push the locking ring into
position.
g. Plug in the foot switch into the back of the SMR. (Refer to figure 5).
h. Plug the power cord into the back of the SMR. (Refer to figure 5).
i.
Plug the power cord into AC power.
PACE Inc, Southern Pines North Carolina
All rights reserved
www.paceworldwide.com
Figure One
Figure Three
SMR System Manual, Rev A
Figure Two
Figure Four
Page 4 of 8
Advertisement
