Table of Contents
Advertisement
Error! Style not defined.
PPP IP extension: If this function is enabled, the WAN IP address
obtained by the modem through built-in dial-up can be directly
assigned to the PC being attached to the modem (at this time, the
modem connects to only one PC). From the aspect of the PC user,
the PC dials up to obtain an IP addres. But actually, the dial-up is
done by the modem.
If this function is disabled, the modem itself obtains the WAN IP
address.
Use Static IP Address: If this function is disabled, the modem
obtains an IP address assigned by an uplink equipment such as BAS,
through PPPoE dial-up.If this function is enabled, the modem uses
this IP address as the WAN IP address.
After entering the PPP user name and password, click Next and the
following page appears.
In this page, you can modify the service name, and enable or disable
the IGMP multicast and WAN service.
Enable IGMP Multicast: IGMP proxy. For example, if you wish
that the PPPoE mode supports IPTV, enable this function.
Enable WAN Service: Enable it, unless you do not want to active
the PVC.
Click Next and the following page appears.
12
Error! Style not defined.
This page shows all the configuration. You can view the default
values of NAT enable and Firewall enable.
To save the settings, click Save. To make any modifications, click
Back. After you click Save, the following page appears.
Note: You need to reboot the modem to activate this WAN interface
and further configure services in this interface.
13
Advertisement
Table of Contents
