SAGEMCOM FAST1704 User Manual page 14

4 Q&A
(1) Q: Why all LED indicators are off?
A:
Check the connection between the power adaptor and the
power socket.
Check the power switch is on or not.
(2) Q: Why LAN LED is not lighting?
A:
Check the connection between the ADSL modem and
your computer, hub, or switch.
Check the running status of your PC, hub, or switch, and
ensure that they are working normally.
(3) Q: Why ADSL LED is not lighting?
A: Check the connection between the ADSL "Line" port and the
wall jack.
(4) Q: Why cannot visit Internet with ADSL LED is on?
A: Ensure that the following information is correctly entered.
VPI/VCI
Username/password.
(5) Q: Why cannot open the Modem Web configuration page?
A: Follow below steps to check the communication between the
computer and modem.
Choose Start > Run from the desktop, and ping
192.168.1.1 (the IP address of the modem).
If the modem cannot be reached, please check following
configuration:
– Type of the network cable
– Connection between the modem and computer
– TCP/IP configuration of you computer
(6) Q: How to load the default setting after incorrect configuration?
A:
Error! Style not defined.
To restore the factory default, keep the device powered on
and push a needle into the hole. Press down the button
about one second and then release.
The default IP address and subnet mask of the modem are
192.168.1.1 and 255.255.255.0 respectively.
The Username and password are admin and admin
respectively.
FCC Caution:
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits
set forth for a uncontrolled environment .This equipment
should be installed and operated with minimum distance 20
cm between the radiator& your body.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
27