Switching Off The Water Softening System; Rinse Aid System; Rinse Aid - Siemens SN55HS00VI User Manual

Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
salt refill indicator off.
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡ The water hardness is max. 26 °E
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
1
Depending on the appliance specifications
¡ The water hardness is 0 - 8 °E.
1.
2.
a
a The display shows Hxx.
a The display shows
3.
4.
a The water softening system is

Rinse aid system

Rinse aid system
Rinse aid system

Rinse aid

For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
erally only be used up to a water
hardness of 26 °E without adding
special salt.
You do not need to use special
salt.
Press ⁠ .
To open the basic settings, press
for 3 seconds.
Press repeatedly until the dis-
play shows H00.
To save the settings, press
for 3 seconds.
switched off and the salt refill indic-
ator is deactivated.
Rinse aid system en
⁠ .
25