Tait TP9310 User Manual page 11

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Radio frequency emissions limits in
Canada
ISEDC warning
This device complies with Innovation, Science and
Economic Development Canada Compliance licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference,including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Under Innovation, Science and Economic
Development Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Innovation, Science and Economic
Development Canada. To reduce potential radio
interference to other users, the antenna type and its
gain should be so chosen that, the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
For your safety 11