Advertisement
4. TROUBLESHOOTING
Some problems can be caused either as the results of simple maintenance operations or
by incorrect selection of settings. Prior to contacting a Service Centre please check the
following chart.
PROBLEM
The appliance is not
working
The electric oven is not
working
The thermostat is not
working
The electric thermostat
warning light does not
switch on during use
The oven light does not
switch on
5. INSTALLATION
5.1Technical information
Warning: Alwais use safety gloves
while handling the cooker.
•
The installation, adjustments,
conversions and maintenance
operations listed in this part
must only be carried out
by qualified personnel. The
manufacturer cannot be held
responsible for any damage to
persons or property resulting
from an incorrect installation of
the appliance.
•
The safety and automatic adjustment
devices of the appliances may,
during its life, only be modified by the
manufacturer or duly authorised supplier.
•
In accordance with the gas standard, the
all-gas and combi appliances are "class
1" (free standing) or "class 2 subclass 1"
(recessed) and, as such, must comply
with the clearances specified in figure
below consequently any side walls must
be no higher than the work top.
REMEDY
•
Make sure the gas tap is open
•
Check the plug is in
•
Check that the knobs are set correctly for cooking and
then repeat the operations given in the handbook
•
Check the electrical system safety switches (RCD). If
there is failure in the system call an electrician in.
•
Check that the programmer accessory, if there is one, is
on the manual position and then repeat the operations
described in the manual
•
Contact Service Centre .
•
Turn the thermostat round to a hotter temperature
•
Turn the selector round to a different function
•
Make sure the lamp is firmly screwed in place
•
Buy a lamp for high temperatures at one of our
Service Centre and fit it following the instructions given
"Replacing the oven lamp" paragraph.
•
•
•
Installation
Unpacking your cooker
•
The walls adjacent to and surrounding
the appliances must be able to
withstand an temperature of 95°C.
The installation of all-gas and combi
appliances must comply with the
standards in force.
This appliance is not connected to a
flue for discharge of the combustion
products; therefore, it must be
connected in compliance with the
above mentioned installation rules.
Particular attention must be paid
to the instructions given below for
ventilation and aeration.
Once the wrapping has been
removed from the outer surfaces and
the various inner parts, thoroughly
check that the appliance is in perfect
condition.
ENGLISH
17
Advertisement
