Download Print this page

Operation - Electrolux EKK066AAOX User & Installation Manual

Advertisement

8
www.electrolux.com
time by pressing the corresponding push
button.
Correcting/cancelling the programme
setting
An automatic function programming
error will occur if the time shown on the
clock is between the cooking start time
and cooking end time. This error will be
signalled immediately by a buzzer and the
AUTO symbol will flash. A setting error
can be corrected by altering the duration
or end of cooking time. Any programme
that has been set can be corrected at

3. OPERATION

3.1Hob: general notes on safety
When a gas cooker is being used
it produces heat and humidity in
the room where it is installed. For
this reason the room must be well
ventilated, keeping the natural
ventilation openings free and
switching on the mechanical aeration
system (suction hood or electric fan,
see "Ventilation" and "Location and
Aeration" paragraphs).
If the cooker is used for a long time
additional aeration may be necessary,
for instance, opening a window, or a
more effective aeration by increasing
the power of the mechanical system if
there is one.
Lighting the burners
Automatic electric ignition of burners
Press and turn the knob corresponding
to the burner you wish to use
counterclockwise to the "Full on" position.
Automatically the ignition spark shoots.
Once lit, keep the knob pressed for about
3 seconds.
Matches can be used to light the burners
in a blackout.
Optimum use of the burners
To get the maximum yield with the
minimum consumption of gas it is handy
to keep the following points in mind:
Once the burner has been lit, adjust
the flame according to your needs.
any time by pressing the corresponding
programming key and then key 5 or 6.
To cancel a programme, correct the
time set bringing it to a value of "0.00".
If functioning time is cancelled the end
of functioning is cancelled too and vice
versa. The oven turns off automatically
and the AUTO symbol flashes. Press
key 4 to set the programmer on manual
operation. The right time cannot be
corrected when the automatic operation
programme is working.
Use an appropriately sized pan for
each burner (see the table below and
fig. 2).
When the content of the pan start to
boil, turn the knob down to "Reduced
rate position" (small flame).
Always put a lid on the pan.
Burners
Ultrarapid
Rapid
Semi-rapid
Auxiliary
fig.1
fig. 2
Ø pan cm
22÷24
20÷22
16÷18
12÷14

Advertisement

loading