Agilent Technologies 10400B Series User Manual page 9

The above curve only applies to 10 MΩ, 10:1 probes with the oscilloscope's input
impedance set to 1 MΩ.
The Agilent 10437B 50Ω probe is rated at 5 V
The Agilent 10442B 500Ω probe is rated at 10 V
I).
Environmental Characteristics
Temperature
(operating)
Humidity (operating)
Altitude (operating)
Shock
Weight
Indoor Use
This symbol indicates that the Agilent 10400B Series Probes are in
compliance with European product regulations, including the
EMC Directive and the Low Voltage Directive.
This symbol indicates that the Agilent 10400B Series Probes are in
compliance with Australian product regulations.
CAT I and CAT II Definitions
Installation category (overvoltage category) I: Signal level, special equipment
or parts of equipment, telecommunication, electronic etc., with smaller transient
overvoltages than installation category (overvoltage category) II.
Installation category (overvoltage category) II: Local level, appliances, portable
equipment etc., with smaller transient overvoltages than installation category
(overvoltage category) III.
WEEE Compliance
\
Agilent 10400B Series Miniature Passive Oscilloscope Probes
0 °C to +55 °C
Up to 95% relative humidity at 40 °C
Up to 4,600 meters (15,000 ft)
50 g (400 g tip only)
2.6 oz.
This product complies with the WEEE Directive (2002/96/EC)
marking requirements. The affixed label indicates that you
must not discard this electrical/electronic productd in
domestic household waste.
Product Category: With reference to the equipment types in the
WEEE Directive Annex I, this product is classed as a
"Monitoring and Control Instrumentation" product.
Do not dispose in domestic household waste.
To return unwanted products, contact your local Agilent
office, or see www.agilent.com for more information.
Probe characteristics
maximum (CAT I).
RMS
(dc + ac ) maximum (CAT
RMS RMS
9