NCI MiniPrinter 122 Series User Manual page 36

Selectable Column Selectable Column Selectable Column Selectable Column Selectable Column The printer powers up in the column mode last selected by
Width Width
Width Width Width configuration. You can change the column width by
Codes 29, 30, 31 Codes 29, 30, 31 Codes 29, 30, 31 sending the appropriate control code from the list below:
Codes 29, 30, 31 Codes 29, 30, 31
You can send the control code at any point on a line
before the buffer becomes filled. You cannot change
column widths on the same line.
P P P P P rintable Characters rintable Characters rintable Characters rintable Characters
rintable Characters The Model 122X printer can produce all ASCII characters
from hex 20 through hex 7D (decimal 32 through 125).
Here's what they look like:
Note the last two codes of the usual ASCII character set
are not supported. Instead, if CHR$(126), which corre-
sponds to hexadecimal 7E, is received by the 122X printer,
it will print the character defined in its RAM (Random
Access Memory). The section on USER Programmable
Character describes how this RAM can be loaded with
any 6 x 8 pattern.
The model 122X also has a graphic character set that
resides between hexidecimal values 80 and FF (decimal
128 and 255). The symbols used are compatible with
Radio Shack® Model 100 portable computer.
31 31 31 31 31
Control code 29 - 24 columns
Control code 30 - 32 columns
Control code 31 - 40 columns