NCI MiniPrinter 122 Series User Manual page 15

With the printer in the setup menu and with
CONFIGURE CONFIGURE CONFIGURE CONFIGURE CONFIGURE
OK OK OK OK OK (right side) to access the CONFIGURE
following is printed:
L L L L L OAD DEF OAD DEFAUL OAD DEF OAD DEF OAD DEF
L L L L L oad Defaults oad Defaults oad Defaults oad Defaults oad Defaults
printer to all default settings (shown below).
* The parallel
interface does not
have these
selections.
Choose OK
eter. The following is printed:
The complete list
of defaults is
shown in the
Default Table at the
end of this manual.
Baud Rate Baud Rate Baud Rate
Baud Rate Baud Rate Baud rate is the next parameter you can set in the
CONFIGURE CONFIGURE CONFIGURE menu. The complete list of parameters and CONFIGURE CONFIGURE
their possible values is shown below.
The sample list above shows the current baud rate is
1200. To accept this, press OK
next baud rate value by pressing NEXT
OK when the baud rate you want is displayed.
Data Bits Data Bits Data Bits Data Bits Data Bits D D D D D A A A A A T T T T T A BITS
value the same way baud rate was chosen. Choices are 7
or 8 data bits.
[NEXT/OK] [NEXT/OK] [NEXT/OK] [NEXT/OK] as the last item printed, press [NEXT/OK]
CONFIGURE menu. The CONFIGURE CONFIGURE CONFIGURE
AUL AUL AULTS TS TS TS TS gives you the opportunity to reset the AUL
OK OK NEXT NEXT
OK to do this or NEXT OK NEXT to go to the next param- NEXT
OK (right side) or view the OK OK OK
Choose from these baud rates;
300, 600, 1200, 2400, 4800, 9600, or 19200
A BITS A BITS
A BITS A BITS is the next parameter. Choose the data bit
NEXT (left side). Press NEXT NEXT NEXT
10 10 10 10 10