Setup Menu Operation - Lincoln Electric LN-25X Operator's Manual

LN-25X™

setUp MenU operation

The LN-25X™ setup menu is accessed through the hidden setup
menu push button that is located below a small hole just right of
the right 4 digit display.
To enter the setup menu, use a paper clip to quickly press and
release the small button located to the right of the voltage display
on the front of the LN-25X™.
The setup menu settings (in order) are:
• Wire feed speed units (metric or English)
• Preflow time
• Run in wire feed speed
• Burnback time
• Postflow time
• Display of actual wire feed speed or arc current
• Arc hours display on/off
• After weld display hold time
• True Voltage Technology (TVT) enable/disable
• CrossLinc™ enable/disable
• CC or CV power source
• Wire feed speed calibration
• Arc voltage display calibration
• Arc current display calibration
The left display will show the menu item, and the right display will
show the set value.
The left encoder is used to select the setup menu item to be
changed. The right encoder will be used to change the set value.
While in the setup menu, there are 3 ways to exit the menu and
return to showing preset settings on the displays.
1. A quick press and release of the setup button.
2. A quick gun trigger closure and release.
3. 30 seconds of inactivity while in the setup menu.
B-5
OPERATION