General Maintenance - Promeba PS-190 User Manual

USER GUIDE // ELECTRIC CHAIR PS-190
Review 11/20
06

GENERAL MAINTENANCE

CLEANING
Keeping the equipment clean is essential to ensure
good use and durability of the assembly. It is necessary
to perform a thorough cleaning periodically, especially
in areas exposed to dirt that can suffer damage such as
gears, connectors, buttons, etc. Do not use high pressu-
re washers, they may damage the electrical elements.
CONTROLS AND SELECTORS
Due to the intense and continuous use of the mova-
ble elements, as the controls and selectors, periodically
check the proper functioning of the same. There may
be faults in the micro-breakers and wiring, check the
fixings and electrical or mechanical connections that
may exist.
OIL
In general, any moving part must be oiled. Our pro-
ducts come from the factory completely oiled and lu-
bricated, however, it is possible that with the time and
use of the product the elements are decreased, either
by loss of lubrication or by dirt. Clean and grease pe-
riodically affected areas, according to manufacturer's
specifications.
Check for loose, missing, or worn parts. Periodically
inspect all moving parts to make sure components are
tight.
ATTENTION: Never lubricate the belts. Lubrication can
cause the belts to work unpredictably, which can cause
injury to the patient and/or operators.
WEARING AREAS
Inspecting regularly to see if there is wear on the sys-
tem components is a preventive measure that can re-
duce breakdowns. Check for possible lubricant leaks,
grooves or bearings in poor condition.
MECHANICAL FASTENING ELEMENTS
In general, we call mechanical fastening elements for
the components that are used to fix the whole of the
product, mainly fasteners and derivatives.
In some conditions of use, due to vibrations and im-
pacts, certain elements can lose their tightening tor-
que or fixing properties.
Check periodically that there are no loose elements,
especially in moving parts of the assembly. Always ob-
serve the recommended tightening torques.
REPLACEMENT OF COMPONENTS
This instruction manual does not include procedures
for all parts. Typically, qualified service personnel re-
place wires, switches and certain mechanical parts wi-
thout the need for step-by-step procedures.
Qualified service personnel should contact our sales
department for information on ordering parts and ins-
talling them.
BE SURE TO KEEP THESE ZONES FREE OF DIRT.
HAVE SPECIAL CARE IN THE CLEANING TO ENSURE A GOOD
FUNCTIONING OF THE SET
25