04.1.10 Track Operation - Promeba PS-190 User Manual

USER GUIDE // ELECTRIC CHAIR PS-190
Review 11/20
04
OPERATING

04.1.10 Track operation

Warnings:
·
The use of the chair on the stairs requires a minimum of two trained operators. It is recommended to use
a third person as an "observer".
·
Verify that the tracking system is completely open and locked before using it.
·
Never lubricate the belts. Lubrication can cause the belts to work unpredictably, which can cause injury to
the patient and/or operators.
·
Moisture, water, snow, ice or debris on or between track and belts can cause uneven belt operation that
causes sudden changes in the weight that operators must bear. Make sure the tracks and belts are clean and
dry before using the chair on the stairs.
·
Humidity, water, snow, ice or debris on ladders can cause poor balance for operators. To avoid possible
injuries, clear the stairs or select an alternative route.
·
This product is suitable for any type of stair
CONTROL PANEL
1 Up
2 Down
3 LED light
4 Increase speed
5 Reduce speed
6 Power button
GO DOWN THE STAIRS
1 Open battery switch.
2 Push the chair to the top of the stairs, and tilt it back.
3 Press and hold he "down" button. The track will go upstairs by itself. You will need to hold it and keep it in
a straight line.
GO UP THE STAIRS
1 Place the chair with its back to the stairs and tilt it.
2 Press and hold the "up" button. The track will go upstairs by itself. You will need to hold it, keep it in a strai-
ght line, and press lightly on the backrest to ensure a steady climbing.
STOP ON THE STAIRS
1 Confirm that the track surface is in contact with at least three steps, then release the raise or lower button.
The chair will remain stable in this position.
ADJUST THE SPEED
1 Press the "up" button and the + or - buttons to adjust the upstairs speed.
2 Press the "down" button and the + or - buttons to adjust the downstairs speed.
2 5 4 3 6
FIGURE 17 CONTROL PANEL FUNCTIONS
1
19